This is our premiere kit for the Honda/Acura J-Series engine. This kit has undergone numerous design iterations, has been tested rigorously for nearly two years without any issues on daily driven vehicles! It has been proven to provide smooth and responsive power on both individual port and monoport J-Series engines. We are the ONLY company with this supercharger kit.

Curious as to the install process? Check out our install guide

Select your engine type, throttle body flange, and map sensor type.

This kit comes with the following parts:

• Plenum Bottom Half
• Plenum Gasket
• Plenum Top Half
• 8x M6x45mm Plenum Bolts
• 2x Supercharger Risers
• 12x Riser Port Gaskets
• 6x Supercharger Studs
• 16x M6x50 Riser Bolts
• 6x M8x1.25 Supercharger Nuts

• 3D Printed Supercharger Sensor Port Block Off
• 3D Printed Supercharger Upper Bypass Valve Block Off
• 3D Printed Supercharger Lower Bypass Valve Block Off
  
• 3D Printed Supercharger EVAP plug (port on the belly of the supercharger)
• 3D Printed Map Sensor Dummy Plug and Adapter
• 3D Printed Supercharger Vacuum Port Adapter (near Audi throttle body flange)
• Aluminum TVS-R1320 Supercharger Throttle Body Flange
• Aluminum Honda/Acura Throttle Body Flange That You Select
  • These are provided so you can fabricate your own intake tube depending on your vehicle.

Note: The 3D printed parts are printed in either PA612-CF15 or PPS-GF20. They are also annealed to ensure maximum strength and heat deflection. These are made to withstand 380˚F – 480˚F!